The overheating of the ball mill equipment will cause harm and failure. In order not to affect the operation of the equipment and production efficiency, how to deal with the overheating and abnormal heating of the ball mill? There are the following points:

When the ball mill is particularly hot in summer, it is normal for the temperature to rise or rise briefly due to long-term work. We can stop the ball mill, let it cool for a while, wait until its temperature returns to normal, and then continue production. This may have an impact on the production schedule, but compared with high temperature causing component damage or reduced grinding efficiency, temporary shutdown is economically feasible.

How to deal with abnormal heating of the ball mill?

1. The oil seal of the ball mill is faulty, the gasket is damaged, the oil volume is too much, the oil plug is loose, and the oil mark is unclear. The oil seal should be replaced, the standard gasket should be replaced, the appropriate amount of lubricating oil should be added, the oil plug should be tightened, and the oil mark should be replaced.

2. The ball mill is overloaded, the lubricating oil is too little or too much, the lubricating oil is of poor quality and unqualified, the oil seal friction is too large, and the output shaft is improperly connected to the transmission device. It should be adjusted to the appropriate load or a large machine should be selected. Add the appropriate lubricant according to the instructions, add the appropriate lubricant after unloading the oil, drip a few drops of lubricant on the oil seal, and adjust it to the appropriate position.

3. The ball mill lubricant is not suitable, the lubricant is insufficient, the bearing is damaged, and the operating temperature is too high. Replace the appropriate lubricant, add the appropriate lubricant as required, replace the bearing, and improve the ventilation environment.

4. The worm gear is overheated, the transmission system device is unstable, the bearing is damaged, the worm gear and worm gear are overused, causing wear. It must be replaced or repaired in time, a transmission control device must be fixed, the bearing must be replaced, the debris must be removed and the lubricant must be replaced, and the worm gear or worm gear must be replaced.